How to solve the problem when the single-plate rotary cutting machine suddenly gets stuck
Sudden jamming of single-plate rotary cutting machine in operation not only affects production efficiency, but also may damage equipment. The following are some countermeasures.
Immediately press the emergency stop button to cut off the power supply to prevent further equipment damage or safety accidents.
Next, check the cause of the sticking. Check whether the rotary cutter is blocked by wood chips. If so, clean it carefully with tools to avoid scratching the cutter. Check the feeding system to see if the feeding of wood is not smooth due to bending, knots and other problems, and timely adjust the position of wood or replace the qualified wood. At the same time, check the transmission parts, such as whether the belt slips, whether the gear is stuck, etc. In case of looseness or damage, fasten or replace it in time.
If the problem cannot be solved after self-inspection, do not start the equipment forcibly and contact the professional maintenance personnel in time. Describe the stuck phenomenon and the measures taken to the maintenance personnel in detail so that they can quickly diagnose and repair.
In daily use, the single-plate rotary cutting machine shall be regularly maintained, the wear of each component shall be checked, the vulnerable parts shall be replaced in time, and the wood chips and dust inside the equipment shall be cleaned to ensure that the equipment is in good operating condition and reduce the occurrence of such faults as jamming.
